Remote Control Over A GSM Cell Phone Network
Text Message Your Control Commands
RS-232 Modem Connection Too | |||||
APPLICATION DIAGRAM
| |||||
INTRO
The C-RC expands these remote control capabilities to places where a standard land telephone line
or TCP/IP network connection may not be available or practical (see other CPS Controllers).
The C-RC also has application for back-up access, semi-permanent or mobile applications. In most
cases the user may borrow a SIM card (Subscriber Identity Module) from a functioning cell phone
on the appropriate network to temporarily use the C-RC.
PORTS
The serial port is normally used for other applications, but it may also be used to locally
configure the C-RC.
Dip switches and LEDs are used to monitor the operation as well as the signal quality. Various
antennas are available to accommodate different environments.
OPERATION
A land-line modem may also be used for remote control instead of text messaging. This may be
viewed as a "dial-up Hyperterm/text session".
The Caller ID feature of the cell phones can also be employed on normal calls for additional
security or for expanded application requirements. Up to 60 "authorized CID numbers"
can be stored in the C-RC. These are stored in EEPROM and not dependent on the SIM card memory.
AUTOMATIC CID "DO" TABLE
The good news is that no minutes are charged since the C-RC only recognizes the CID and never
really answers the call. This allows subscription to a basic low cost service with no free
minutes. However, modifying the CID list or table requires chargeable minutes if done remotely.
USER RESPONSIBILITY
Additional features are planed for this product as it evolves. Please let us know if you have
a specific area of interest.
Orders are being accepted for Jan/05 delivery.
SPECIFICATIONS
CELL REMOTE CONTROLLER (C-RC) Item No SWTCRC Price $425.00 Includes ex-power antenna Physical 4.5" W x 3.5" D x 1.5" H, .5 lbs. Connectors (2) RJ-11 Control/Extra Controller, (1) DB-9 Female RS-232, (1) 3V SIM Slot, (1) 1 MMCX Antenna Connector LEDs (4) Power, Mode, Signal Strength Switches (1) 4-Bit Dip Bell None Cable (1) 5' RJ-11 Cable, (1) 6' DB-9 Female to DB-9 Male Adaptor None AC Power Wall Mount 5VAC 2.6A, 115V/60Hz NOTE: For 220V/50Hz, add (-INT) to the Item No ------ NON-ADDRESSABLE BASE UNITS ------ OPTIONAL INTELLIGENT AC POWER STRIP 2 Controlled and 4 "Normal" Outlets Item No SWTARR-2x4 Price $ 89.00 4 Controlled and 2 "Normal" Outlets Item No SWTARR-4x2 Price $ 89.00 6 Controlled Outlets Item No SWTARR-6x0 Price $ 89.00 Physical 12" W x 2.5" D x 1.5" H, 2 lbs. Connectors (2) RJ-11 TelCo/Control, (6) AC Receptacles LEDs (1) Surge Protection Switches (1) Main Toggle On/Off Bell None Cable (1) 5' RJ-11 Phone Cable Adaptor None AC Power 115V/60Hz, 15 Amps NOTE: For 220V/50Hz, see the IPC. OPTIONAL INTERNATIONAL POWER CONTROLLER (IPC) See the IPC OPTIONAL PC-RJ CABLE INTERFACE ASSEMBLY Item No CAPC2-RJ Price $ 15.00 Physical 5.5" W x 2.5" D x .75" H, .25 lbs. Connectors (1) RJ-11 Interface, (4) PC Headers Pins LEDs None Switches None Bell None Cable (1) 2' M/F Reset Switch Cable, (1) 2' F/F Motherboard Reset Cable, (1) 5' RJ-11 Cable Adaptor None AC Power None OPTIONAL RELAY BOX See the Relay Box -------- ADDRESSABLE BASE UNITS -------- OPTIONAL A/B, MATRIX or X2 SWITCH See the AB-M OPTIONAL INTELLIGENT AUTO PUSH BOARD (I-APB) See the APB OPTIONAL INTELLIGENT POWER NODE (IPN) See the IPN OPTIONAL RELAY CONCENTRATOR See the Relay Concentrator | |||||
Computer Peripheral Systems, Inc. © Copyright 1996-2004 Computer Peripheral Systems, Inc. |