Home
About CPS
Product Categories
· Telephone Line Sharing
· Dial Security
· ReBooting &
AC Power Control
· Remote Switching
· RS-232
· Controllers
· Software
· 50 Products
· Alphabetic Listing
Administrative
· Ordering
· Warranty
· Discounts
· Return Policy/Demos
Technical
· Tech Tips
· Wish List
· Best Way
· Security...Heard at the Booth
|
RS-232 PRODUCTS
(Synchronous and Asynchronous)
The RS-232 SHARING PRODUCTS (MODEM SHARING, PORT SHARING, and CABLING HUBS) are
normally used on polled main frame type networks where the terminals or a
cluster controller have unique device address.
The SIGNAL BOOSTERS, SIGNAL CONVERTERS, and SHORT RANGE MODEMS may be used on
any RS-232 line.
Note that not all of the following products support all of the RS-232 signals.
When making your selection it is important to determine if your requirement
is for Synchronous or Asynchronous transmission and how many of the RS-232
control signals are required. To help you make your selection, a small
application chart accompanies each product.
Modem Sharing Products
These products allow multiple addressable terminals to share a single modem.
They are normally used at a remote location, but can also be used at the host
site using a null modem cable.
|
$95.00
|
TD-2 -
2 to 1 Signal Powered Splitter
This is a convenient low cost sharing unit with two female DB-25
terminal connectors and one male DTE connector. It is designed to
connect to the terminal and provide a "down stream" port in a daisy
chain fashion. Up to four units can be used in a daisy chain. The
total combined cable distance should not exceed 150' at 9600 bps and
100' or less at 19.2 KB.
|
|
$155.00
|
DeCAT -
4 to 1 Signal Powered Splitter
Four port signal powered sharing unit. No AC power required. LEDs
define RTS and receive data on all ports. One DB-25 Male DTE and four
DB-25 female DCE connectors. Combined cable distances from all of the
ports may not exceed 125 feet.
|
|
$250.00
|
ASR-32 -
8 to 1 AC Powered Splitter
Eight port AC powered sharing unit. LEDs define receive data on all
ports. One DB-25 Male DTE and eight DB-25 female DCE connectors.
Cable distance up to 150' from each port. Support 3-wire RS-232
(pins 2, 3, & 7).
|
|
$395.00
|
SSD-32 -
8 to 1 AC Powered Splitter
Cable Distances Up To 2000' Per Port
Eight port sharing unit. LEDs define RTS and receive data on all ports.
LEDs on the Host port addresses additional signals. One DB-25 Male DTE
and eight DB-25 female DCE connectors. Cable distances up to 2000' from
each port. Return signal booster may be required at each terminal where
cable distance exceeds 150'. See TB-32.
|
|
RS-232 Signal Boosters
These products can be used in the middle of a RS-232 cable run to regenerate
the RS-232 signals. They can also be used in pairs similar to short range
modems, except that the signal is not converted between them.
|
$159.00
|
TB-32 -
Multi-Purpose RS-232 Sync or Async Signal Driver
The TB-32 is a general purpose RS-232 signal driver that can be
used for a variety of RS-232 synchronous or asynchronous applications.
It incorporates CPS's exclusive Super Serial Driver (SSD) that can
drive the RS-232 signals up to 1500' when used in conjunction with
other CPS products that employ the same driver. See
SSD-32.
It may be used in pairs similar to short range modems, but with 11
conductor cable, at distances of up to 2000+ feet. It can also be used
as a stand alone product in the middle of a sync or asynchronous RS-232
line to clean up and regenerate the appropriate RS-232 DCE and DTE
signals.
|
|
RS-232 Signal Converters
These products convert the RS-232 signal to another signal discipline such an
RS-422, fiber optic, USB, etc. The converted signal can be used by another device with
a compatible interface or the products can be used in pairs, as Short Haul Modems
to operate over longer distances. The second unit re-converts the signal back
to RS-232.
|
$135.00
|
F-232 -
Flexible Mini RS-232 to Fiber Optic Converter
This asynchronous RS-232 to Fiber Optic converter is built in a
DB-25 gender mender sized enclosure. It can be used as a stand alone
unit connected directly to the RS-232 port of a terminal, PC, modem, or
mux.
|
|
$16.95
|
USB to SERIAL CONVERTER CABLE
Allows serial devices to connect to a PC via its USB port or USB hub.
|
|
Excess & Obsolete Inventory
Additional RS-232 Products
- BULK CABLE
- CABLE ASSEMBLIES (molded)
- CABLE FABRICATING PARTS
- CRIMP TOOLS
- PATCH PANELS
- RS-232 MISC
- RS-232 CONVERTERS and BOOSTERS
- MODEMS (short range/long range)
- SWITCHES A-B-C
- SURGE PROTECTORS
|
|
Computer Peripheral Systems, Inc.
5096 Bristol Industrial Way, Suite B
Buford, GA 30518
Sales
1-800-888-0051
8:30 AM - 5:30 PM EST
Technical Support
(770) 945-0643
8:30 AM - 5:30 PM EST
Fax
(770) 945-9342
E-Mail
sales@cpscom.com
|